Toilet Flange Above Floor Level

In most cases the floor of a bathroom is tiled and in this case the tiling is done after the flange is installed.

Toilet flange above floor level. This would allow you to use a sponge gasket if you wanted to. You can use a hammer and a chisel. The optimum toilet flange height is approximately inch above the floor to achieve the best seal and overall fit. Purchase a new one if the previous flange is too low purchase one that is designed to sit on the finished floor and provide the optimum toilet flange height.

Once you find the right spacer for your needs pay. Though above floor installation is considered the right way to fit a flange some swear by attaching it level with the floor. In the set rite system there s four different. We in canada place our platic flanges flush with the finished surface level with the tile floor and or 1 8 higher than the finished surface.

Next you ll want to choose the right spacer from the extender system. Remove your broken flange if you re replacing it and insert the new one into the waste pipe. Your flange should be now. With the toilet removed you can see the toilet flange and measure its height above the floor.

In both cases always fastening the flange to the floor or subfloor. The flange should sit on top of the finished floor if it doesn t you ll have to modify the plumbing or find another way to achieve this. To get the fitting out from the inside of the pipe you ll want to make two score cuts less than an inch between each. Notice in this image how the toilet waste pipe sits just inside the flange opening this is the proper way for a toilet to sit on a flange.

Start by removing your toilet and breaking the outer flange portion off. Once the outer portion of the flange and the fitting has. This typically allows for almost any type of wax ring to be used and still ensure a good seal. Give some thought to the height of the finished floor and you should be able to work out how high it needs to be.

If it s a little too low then this probably won t be an issue. The process is generally the same but the flange is secured down before the floor is finished. This particular toilet flange was 5 8 above the floor level.